Questions concerning the hydraulic- and spindle lift systems of Ergoswiss

HX = hydraulic lift system / drive technology = with oil / consisting of: hand crank / motor + pump + lift elements

SX = spindle lift system / drive technology = spindle-linear actuator / consisting of: = push button / controller + spindle lifting column

No, the max. permissible total load is not solely dependent on the number of lifting elements. The max. permissible total load is also limited by the selected pump or controller. See System Combination Tables:
https://www.ergoswiss.com/en/services/downloads

No, the speed of a hydraulic lift system is dependent on the combination of the respective pump type + lifting element type.The speed of a spindle lift system is dependent on the combination of the respective controller type + lifting column type. See System Combination Tables:
https://www.ergoswiss.com/en/services/downloads

All our lifting elements are made of aluminum, except the SE, TA and TU. These are made of steel.

Yes, our lifting elements have undergone a special process, they are therefore rust-free.If you require any details of the individual components, please contact us.

Motor and operation = IP 30

Controller = IP 20

Our lift systems have been developed in accordance with the machinery directives and certified according to the EU/US directives. If you require details about the individual components, please contact us.

You can easily contact us by telephone or E-Mail, we will then gladly send you all important information concerning the ESD directives.

Mains voltage CH/EU = 230V / US/CA = 110V / 24V control (for battery solution)

Our systems are designed and tested for a room temperature between +10 and +40 degrees Celsius.

Yes, we also offer a battery solution. Please contact us directly about it.

Yes, we provide all components for a mobile solution, such as e.g. the battery, crank and the lifting rollers.

On our website under "Downloads" you will find all operating instructions. In the operating instructions all error messages are described and explained.
https://www.ergoswiss.com/en/services/downloads

With the hydraulic lift system, in an emergency you could dismantle the motor from the pump and operate the pump with a hand crank. With the spindle lift system this is not possible, because the option with the hand crank is not provided.

The lift system is maintenance-free if used as intended.

The system is not suitable for continuous operation. Please observe the switch-ON duration (see operating instructions).
https://www.ergoswiss.com/en/services/downloads

HX: Install the lifting elements only vertical, in doing so the installation position is irrelevant. ATTENTION: Reset force must always be ensured.

SX: Install the lifting elements only vertical, in doing so the installation position is irrelevant. ATTENTION: Observe max. permissible tensile load.

SLX: Lifting element can be installed vertically or horizontally, in doing so the installation position is irrelevant.

With our SLX product variants this is possible up to a weight of 150kg per unit (see System Combination Tables).

Our hydraulic lift systems are not designed for a tensile load.

The controller and the cable remote control may only be cleaned with a dry or lightly moistened cloth. No liquid must get into the plug connections.

Attention: Before cleaning, the mains cable must be disconnected from the mains without fail.

Your question is not listed?

Skontaktuj się z nami